79 Results
This document provides the technical specifications of the R&S®ESCU enhanced signal conditioning unit.
Using the ZN-Z103 calibration unit with the FPC1500
ZNB/ZND - wrong connector type shown at Cal Unit Characterization
FAQ: Unit Conversion
Calibration Unit and Remote Calibration
I want to do a calibration with 75 Ohms at the ZNB/ZND/ZVA. Do these VNAs accept the auto cal unit ZV-Z53 with 75 Ohms impedance?
Remote control autocalibration with a calibration unit
Rackmount kit for Calibration Unit ZN-Z154
FAQ - Remote command „CALC:UNIT:POW DBUV” is not accepted
When I start a calibration with an auto cal unit I get the following warning. What does that mean?
I would also like to use a Switch Unit to switch between the antennas. How can I configure swiched signal pathes with ELEKTRA?
Active cal kit or cal unit does not contain all standards needed for selected cal procedure.
Is there a way to use the hard keys when using the ZNB via Remote Desktop connection? On my unit I only see the standard menu to the lower left side of the device, but have no access to the "master keyboard"
I tried to measure the Voltage Noise of my power supply unit which is specified to the following values. My results have been much higher and I sent in the device for alignment/calibration. After getting it back I still gather the same results. Can you explain how to perform such a measurement?
I would like to be sure about the high impedance state of a dedicated channel for my power supply unit. Do you have a process to test and to ensure that? Can you also please explain, how the high impedance mode works?
R&S®NGU201 Source measure unit - Compsheet Brochures and Data Sheets
R&S CMW-ZSIM UICC Switch and Programming Unit - Specifications
How Kyrio found its perfect O-RAN conformance T&M solution from Rohde & Schwarz and VIAVI Solutions.
The R&S®ESCU enhanced signal conditioning unit significantly boosts system sensitivity to electromagnetic interference (EMI) and radiated spurious emission (RSE) and can also withstand unintended pulses and electrostatic discharges (ESD), particularly at its input.
R&S®PDU4003 Power Distribution Unit - Product Brochure
R&S®PDU4002 Power Distribution Unit - Product Brochure
The R&S®FU129 antenna filter unit is placed close to the receiving antennas. It comes with an antenna input selector for remote controlled switching of up to six antenna inputs to one output. Unwanted signals, such as those caused by nearby mobile base stations or strong sound and TV broadcast transmitters, can be reduced to levels suitable for the connected receiver by applying optional filters. Both strong useful signals and interfering signals can be suppressed.