Application Notes for R&S®CBT/CBT32

Learn how to configure Rohde & Schwarz products to fit your application.

More downloads
Filter by Content

Website Content

Find more relevant information about our Products and Solutions.

7 Results

Bluetooth® Low Energy Measurements Using R&S®CBTgo; Additional Tests

Nearly all tests in accordance with the Bluetooth low energy test specification V4.0 [1] can be performed using the R&S®CBT alone. Some tests additionally call for signal generators to provide interference signals. This application note describes the tests performed with additional equipment and presents straightforward solutions based on the R&S®CBTgo software.

18-Jul-2013 | AN-No. 1MA200

Bluetooth® Measurements Using R&S®CBTgo: Additional Tests

Nearly all tests in accordance with the test specification* can be performed with the R&S® CMU200/CBT alone. Some tests additionally call for signal generators to provide interference signals and also require spectrum analyzers. This application note describes the tests performed with additional equipment and presents straightforward solutions based on the CBTgo software.

06-Mar-2013 | AN-No. 1MA106

Development Hints and Best Practices for Using Instrument Drivers

The aim of this application note is to provide information regarding Rohde & Schwarz instrument drivers. This paper shall help application engineers and software developers to easily get an understanding of advanced techniques to develop test and measurement (T&M) applications by utilizing Rohde & Schwarz instrument drivers. Furthermore the nomenclature used for Rohde & Schwarz instrument drivers will be explained.

01-Jan-2013 | AN-No. 1MA153

Rohde & Schwarz Drivers under VEE - Installation and Troubleshooting

The use of Rohde & Schwarz device drivers under VEE software is not complicated. However, a number of factors are involved, the errors that occur are often difficult to diagnose. This application provides easy and detailed support for installation and troubleshooting using National Instruments or Agilent GPIB boards.

20-Dec-2012 | AN-No. 1MA035

How to create a Hardcopy using R&S Instrument Drivers

This application note explains how to create screenshots of Rohde & Schwarz instruments using instrument drivers. The presented examples are written in C (LabWindows/CVI), C# programming language and LabVIEW. The examples are available at the instrument driver download site.

11-Dec-2009 | AN-No. 1MA160

CMUCopy - Transferring CMU Hardcopy to PC using the IEEE Bus or the serial interface

This application note has been replaced by application note .

28-Aug-2009 | AN-No. 1MA45

Measurements on Bluetooth Devices using R&S®CMU200 and R&S®CMUgo

This application note describes how Bluetooth devices are tested and measured using the R&S CMU200/CBT by means of the CMUgo/CBTgo remote control program or manual operation.

06-Oct-2006 | AN-No. 1CM50