Learn how to configure Rohde & Schwarz products to fit your application.
35 Results
R&S®VISA is a standardized software library that allows fast communications over diverse interfaces with a wide variety of T&M instruments that are detected on the network from PC applications.
English - 26. maj 2020
Fault identification in single elements of antenna arrays is possible by scanning in near-field range and applying the near-field to far-field transformation method.
English - 24. mar. 2020
R&S®Forum for Instrument Remote Control
English - 28. jun. 2018
Inside the lab and on the production line – this Rohde & Schwarz solution offers speed, accuracy and convenience for testing TX beamforming passive array antennas.
English - 4. maj 2018
English - 29. sep. 2017
This application note outlines two different approaches for remote-controlling Rohde & Schwarz instruments out of MathWorks MATLAB.
English - 12. jun. 2017
This document describes the unique application of Rohde & Schwarz VNA to fully characterize the passive part of multi-element antennas.
English - 20. mar. 2017
This application note focuses on satellite post-launch or on-orbit measurement and monitoring strategies used for satellite functionality checks.
English - 25. nov. 2016
This white paper provides an overview of test solutions addressing current and future requirements for antenna verification.
English - 11. nov. 2016
This application note aims to explain test procedures and characterization of the relevant parameters for active phased array antennas.
English - 4. jul. 2016
This application note describes methods using an R&S®ZVA network analyzer to accurately measure all the key parameters of frequency converters.
English - 30. apr. 2015
Hints and Tricks for Remote Control of Spectrum and Network Analyzers
English - 19. aug. 2014
R&S®ZVA, R&S®ZVT Application Sheets
English - 28. jul. 2014
Welcome to this introductory video show about the R&S ZVA family of network analyzers.
English - 13. feb. 2014
Direct remote control of OSP via VNA and SA
English - 6. dec. 2013
Use the R&S®ZVA vector network analyzer and R&S®BBA150 broadband amplifier for accurate and reproducible results in minimum test time.
English - 27. sep. 2013
This application notes introduces two alternative methods how to do the Power Added Efficiency measurement.
English - 22. maj 2013
The R&S®ZVA and the R&S®ZVA-K9 option enables absolute group delay measurements on devices with embedded LO.
English - 17. maj 2013
Testing S-Parameters on Pulsed Radar Power Amplifier Modules
English - 11. apr. 2013
This document describes how a Windows®-based R&S® T&M instrument is remotely operated by an Apple iPad as if working on it locally.
English - 28. mar. 2013
Development Hints and Best Practices for Using Instrument Drivers
English - 1. jan. 2013
Rohde & Schwarz Drivers under VEE - Installation and Troubleshooting
English - 20. dec. 2012
Noise Figure Measurement without a Noise Source on a Vector Network Analyzer
English - 27. okt. 2010
How to create a Hardcopy using R&S®Instrument Drivers
English - 11. dec. 2009
GPIBShot - Taking Screenshots via IEEE Bus
English - 28. aug. 2009
S-Parameters of a 50 to 75 Ohm impedance matching device using R&S ZVx VNA
English - 6. maj 2009
Testing Millimeter-Wave Mixers Using Converters of the R&S®ZVA Family
English - 17. nov. 2008
Tackling the Challenges of Pulsed Signal Measurements
English - 18. jan. 2008
Millimeter-Wave Measurements Using Converters of the R&S® ZVA Family
English - 9. okt. 2007
Multiport Millimeter-Wave Measurements Using Converters of the R&S® ZVA Family
