Question
I have tried to set up EMCAN64 together with EMC32 V11 and CANalyser.
Somehow I not see the Environment tab on EMCAN.
Would you please check?
Environment tab on EMCAN64
Answer
The R&S EMCAN64 software, commanded by EMC32/ELEKTRA during EMS Test, queries the values of predefined CAN / LIN or FlexRay bus signals and system variables. "Environment Variables" being observed with CANoe only. If you are using CAN Analyzer this facet can not be displayed.
Example:
Environment tab on EMCAN64
In this case, please upgrade from CAN Analyzer to CANoe. Please keep in mind that CAN Analyzer and CANoe are not Rohde & Schwarz products. For the upgrade information it is recommended to contact the responsible software vendor.
