How do I add a transducer for an 8-Wire ISN as to EMC32?

Question

How do I add a transducer for an 8-Wire ISN (e.g. ENY81) to EMC32? Correction data are available. So far I only have experience how to add a transducer to a slidebar, a 2-Line-LISN or 4-Line LISN.

Answer

It is possible, for sure. You can use typical values from the data sheet or calibrated values. For ENY81, you have to select he type "Transducer" from Device List.

Add this device to your list of "Configured Devices" and rename it according to your needs.

Open the device Properties and define the RF Parameters as follows:

For the "Measurement Correction" I do it in the following Way: I have defined "Additional Attenuation" with 0 dB and for the Transducer Configuration I have selected a "Transfer Characteristic". Here I have to select Transducer Correction Table for the device.

For sure, the Transducer Correction Table must have been created previously.

From now, you can add the device to Hardware Setup.