6 Results
The R&S spectrum analyzers and signal analyzers offer an additional equalizer filter in the Vector Signal Analysis Application Firmware R&S FSQ-K70/FSx-B73, which is a powerful tool for measurement and analysis of vector-modulated signals. This application note describes the functionality of the equalizer filter and how to set the filter parameter manually in an accurate and fast way.
This application note describes how to generate test signals for 13.56 MHz RFID modules according to ISO 15693 with R&S Signal Generators and analyze them with R&S Signal Analyzers using software R&S WinIQSIM™.
The R&S VSA and R&S UAF video analyzers have been designed for measurements on CCVS signals. Under certain conditions, they can also be used for measuring the primary colour components RGB and TV signals in the S-Video format.
Since the video signal - composite or component - is a most complex one regarding the spectral density or even the group delay in the baseband, you need special procedures to measure the signal parameters with an objective and absolute accuracy of less than one percent over the whole frequency range up to 6 MHz. The following describes a method allowing the precise measurement of a baseband signal, which then may be taken for the calibration of video analyzers such as the well-known R&S units UAF or UVF and future products.
- not available -