Learn how to configure Rohde & Schwarz products to fit your application.
35 Results
R&S®VISA is a standardized software library that allows fast communications over diverse interfaces with a wide variety of T&M instruments that are detected on the network from PC applications.
English - 2020. máj. 26.
Fault identification in single elements of antenna arrays is possible by scanning in near-field range and applying the near-field to far-field transformation method.
English - 2020. márc. 24.
R&S®Forum for Instrument Remote Control
English - 2018. jún. 28.
Inside the lab and on the production line – this Rohde & Schwarz solution offers speed, accuracy and convenience for testing TX beamforming passive array antennas.
English - 2018. máj. 4.
English - 2017. szept. 29.
This application note outlines two different approaches for remote-controlling Rohde & Schwarz instruments out of MathWorks MATLAB.
English - 2017. jún. 12.
This document describes the unique application of Rohde & Schwarz VNA to fully characterize the passive part of multi-element antennas.
English - 2017. márc. 20.
This application note focuses on satellite post-launch or on-orbit measurement and monitoring strategies used for satellite functionality checks.
English - 2016. nov. 25.
This white paper provides an overview of test solutions addressing current and future requirements for antenna verification.
English - 2016. nov. 11.
This application note aims to explain test procedures and characterization of the relevant parameters for active phased array antennas.
English - 2016. júl. 4.
This application note describes methods using an R&S®ZVA network analyzer to accurately measure all the key parameters of frequency converters.
English - 2015. ápr. 30.
Hints and Tricks for Remote Control of Spectrum and Network Analyzers
English - 2014. aug. 19.
R&S®ZVA, R&S®ZVT Application Sheets
English - 2014. júl. 28.
Welcome to this introductory video show about the R&S ZVA family of network analyzers.
English - 2014. febr. 13.
Direct remote control of OSP via VNA and SA
English - 2013. dec. 6.
Use the R&S®ZVA vector network analyzer and R&S®BBA150 broadband amplifier for accurate and reproducible results in minimum test time.
English - 2013. szept. 27.
This application notes introduces two alternative methods how to do the Power Added Efficiency measurement.
English - 2013. máj. 22.
The R&S®ZVA and the R&S®ZVA-K9 option enables absolute group delay measurements on devices with embedded LO.
English - 2013. máj. 17.
Testing S-Parameters on Pulsed Radar Power Amplifier Modules
English - 2013. ápr. 11.
This document describes how a Windows®-based R&S® T&M instrument is remotely operated by an Apple iPad as if working on it locally.
English - 2013. márc. 28.
Development Hints and Best Practices for Using Instrument Drivers
English - 2013. jan. 1.
Rohde & Schwarz Drivers under VEE - Installation and Troubleshooting
English - 2012. dec. 20.
Noise Figure Measurement without a Noise Source on a Vector Network Analyzer
English - 2010. okt. 27.
How to create a Hardcopy using R&S®Instrument Drivers
English - 2009. dec. 11.
GPIBShot - Taking Screenshots via IEEE Bus
English - 2009. aug. 28.
S-Parameters of a 50 to 75 Ohm impedance matching device using R&S ZVx VNA
English - 2009. máj. 6.
Testing Millimeter-Wave Mixers Using Converters of the R&S®ZVA Family
English - 2008. nov. 17.
Tackling the Challenges of Pulsed Signal Measurements
English - 2008. jan. 18.
Millimeter-Wave Measurements Using Converters of the R&S® ZVA Family
English - 2007. okt. 9.
Multiport Millimeter-Wave Measurements Using Converters of the R&S® ZVA Family