R&S®FSVR - FAQ
-
Sending a Remote Control Ccommand Internally
I need to send a remote control command to the device, but I do not have a PC available to control the device.Can I do this internally with the device itself?Yes, Go to the device's Windows function Open the Windows Explorer Open the C:\Program Files\Rohde&Schwarz\Network Analyzer\Bin folder Execute the iecwin32.exe program Choose the RSIB interface and push the Connect Now button Now you can write
-
Different frequency data export using ASCII trace export SCPI commands
-
How to automatically transfer IQ-data from FSVR Spectrum Analyzer to VSE software
Name Last Modified SizeFSVR_IQ-data_transfer.py Mar 24, 2020 1 kB """ This simple Python example shows how to tranfer an IQ-data file from Spectrum Analyzer to the controller PC and open it with VSE signal analysis software. Tested with FSVR Real-Time Spectrum Analyzer. Updated on 24.03.2020 """ import pyvisa rm = pyvisa.ResourceManager() instr = rm.open_resource('TCPIP::192.168.0.1::INSTR') # replace
-
SCPI Command Tracking
How do I perform SCPI command tracking?Using command tracking on the R&S FSL/FSV:- Turn on command tracking using the menu Setup/General Setup/GPIB/(FSL: More)/I/O Logging On- Start the remote program- After executing the remote program, you can browse through the log file located in the following folders:c:\R_S\Instr\scpilogging\ScpiLog.txtor for newer firmware versions:c:\Program Files\Rohde-Schwarz
-
Spectrum Analyzers - Export of trace data into a CSV file via remote control
Name Last Modified SizeFPL_Measurement_to_CSV.zip Dec 10, 2020 77 kB
-
Self Alignment via remote control via TCP/IP => 'CAL?
I want to make the Self Alignment via remote control with the command 'CAL?'.Because this takes sometimes a very long time how can I detect the end.In the manual is mentioned to use a SRQ, but this does not work when I use a TCP/IP connectionYes, the SRQ line is a hardware line with the IEEE bus and this does not work with normal TCP/IP. So we cannot use it.Because the calibration command is a query
-
Measurement points of a spectrum analyzer
-
Dongle necessary for FS-K96?
Is an FSPC license dongle (1310.0002.03) always needed to run the FS-K96 software?Yes, the FSPC is always needed for doing measurements. Without an FSPC and a license key, the FS-K96 software will operate in the demo mode - with no analyzer connection and access to only a few demonstration files.There are, however, two different versions of K96:FS-K96PC (1310.0219.06) can be run on a PC and used with
