Vector network analyzers Group delay measurements

Group delay measurement on devices with embedded LO using option R&S ZVA-K9

Group delay measurement on devices with embedded LO using option R&S ZVA-K9

This video demonstrates group delay and relative phase measurements on frequency converting devices where access to the LO is limited. The measurements are made using the R&S®ZVA vector network analyzer equipped with the R&S®ZVA-K9 embedded LO mixer delay measurements option from Rohde & Schwarz. Based on a unique and novel two-tone method, mixers and frequency converters can be characterized in a very simple and convenient way.

Related videos

Level-controlled passive intermodulation (PIM) measurements presented at EuMW 2013

Passive intermodulation

Level-controlled passive intermodulation (PIM) measurements presented at EuMW 2013

Rohde & Schwarz demonstrated fast and accurate passive intermodulation (PIM) testing of duplex filters at the European Microwave Week 2013 in Nuremberg.

Satellite measurements without LO access presented at EuMW 2013

Satellite measurements without LO access presented at EuMW 2013

Rohde & Schwarz presented group delay measurements on converters without LO access at the European Microwave Week 2013 in Nuremberg.

Simplified test setup using R&S®ZVAB-K30 noise figure measurement option

Simplified test setup using R&S®ZVAB-K30 noise figure measurement option

This video demonstrates the simple and straight-forward calibration steps including power calibration of source and receivers, noise figure calibration and system error correction, and the noise figure measurement.

Signal integrity – calibrating a 4-port network analyzer (part 1 of 4)

Development Signal integrity Vector network analyzers

Signal integrity – calibrating a 4-port network analyzer (part 1 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring rise time using a true differential signal (part 2 of 4)

Signal integrity Vector network analyzers

Signal integrity – measuring rise time using a true differential signal (part 2 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring differential impedance vs. distance (part 3 of 4)

Development Signal integrity Vector network analyzers

Signal integrity – measuring differential impedance vs. distance (part 3 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring time domain skew between two lines on a differential transmission (part 4 of 4)

Vector network analyzers Signal integrity

Signal integrity – measuring time domain skew between two lines on a differential transmission (part 4 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Millimeter wave measurements in one sweep with the R&S®ZVA110 presented at EuMW 2012

Vector network analyzers mmWave testing

Millimeter wave measurements in one sweep with the R&S®ZVA110 presented at EuMW 2012

Rohde & Schwarz presented the R&S®ZVA110 vector network analyzer at the European Microwave Week 2012 in Amsterdam.

Request information

Do you have questions or need additional information? Simply fill out this form and we will get right back to you.

Mr.

Ms.

No information

First name

Last name

E-mail

Company

Country

Phone (e.g. +1 400 123 5678)

Zip

City

Inquiry

Email confirmation (optional)

Your request has been sent successfully. We will contact you shortly.

An error is occurred, please try it again later.