Press releases

Munich 9月 17, 2018

Rohde & Schwarz presents solutions for optimizing power electronics

High voltage differential broadband probes allow analysis of switching behavior in fast switching semiconductors. High-sensitivity oscilloscopes with fast FFT functionality combined with near-field probes help developers minimize unwanted EMC emissions in switched-mode power supplies. All-in-one power analyzers enable characterization of energy consumption from µW to kW. Rohde & Schwarz is presenting this portfolio for today's development requirements in power electronics at the EPE Conference in Riga from September 17 to 21, 2018.

Thanks to its powerful FFT function and high sensitivity, the R&S RTO2000 can analyze and optimize EMC during development.
Thanks to its powerful FFT function and high sensitivity, the R&S RTO2000 can analyze and optimize EMC during development.

The Rohde & Schwarz range of innovative test and measurement solutions meets the increasing high T&M requirements for power electronics. Large measurement bandwidths are needed to analyze the switching behavior of fast-switching semiconductors, which leads to new challenges in EMC compliance. The extensive Rohde & Schwarz T&M portfolio meets these needs with a selection of products for power electronics.

2 GHz bandwidth for 48 V applications and 200 MHz bandwidth for voltages up to 6 kV

Rohde & Schwarz offers the R&S RT-ZHD series of high voltage differential probes for maximum peak voltages between 750 V and 6 kV. Featuring up to 200 MHz bandwidth, excellent common mode rejection and up to 2000 V offset compensation, the probes are ideal for analyzing the switching behavior of jumpers as well as small ripple voltages on high DC link voltages. The DC accuracy of 0.5 percent, or just 0.1 percent when using the DC voltmeter integrated into the probe, is also exceptional.

High bandwidth measurements on 48 V systems are possible with the 1 GHz R&S RT-ZD10 broadband probe and the 2 GHz R&S RT-ZD20 probe. With the optional R&S RT-ZA15 10:1 attenuator (included as standard with the R&S RT-ZD10), voltages up to 50 V can be measured with an offset compensation range of ±50 V. Other probe highlights include the very low input capacitance of only 1.3 pF and very short, low-inductance solder contacts. This makes them especially attractive for measurements on wide bandgap semiconductors.

Complete integration of the R&S RT-ZHD probes into the user interface of oscilloscopes from Rohde & Schwarz eliminates erroneous readings and safety risks. The oscilloscopes automatically recognize the configured attenuation factor and all other probe settings so they always display the correct voltages and reliably detect incidents such as overvoltage.

Well prepared for EMC compliance with oscilloscopes

The trend toward ever faster switching power electronics also impacts EMC compliance. The steep switching edges generate unwanted interference emissions that can propagate through connecting cables or in some cases even be radiated directly. Filter circuits or shielding are often necessary to comply with specified limits – which is important for CE certification – and such components increase the cost and weight of the finished product.

Thanks to the powerful FFT function and high sensitivity of Rohde & Schwarz oscilloscopes such as the R&S RTM3000, R&S RTA4000 and R&S RTO2000, it is possible to analyze and optimize EMC during development right on the lab bench. In complicated electronic circuits, it is not always possible to clearly identify the source of interference emissions or the effect of filter circuits. Near-field probe sets such as the R&S HZ-17 from Rohde & Schwarz are valuable tools for such applications. They can be used to reveal unexpected effects such as electrical or magnetic coupling of electrolytic capacitors, coils, driver circuits and heat sinks – a major advantage for further development.

When used with the R&S RT-ZHD high voltage differential probes, for example, it is possible to immediately qualitatively assess the influence of a modified gate drive on interference emissions since both the time domain signal and the interference emission spectra can be clearly correlated.

The R&S HMC8015 power analyzer can be used to measure conducted interference emissions in line with EN 61000-3-2. Users can document compliance with relevant limits. Integrated wizards prevent measurement errors. The hardware-based integrator allows standby energy efficiency measurements to be performed in line with IEC 62301 and EN 50564 – another important factor for the CE mark.

Rohde & Schwarz at the EPE Conference

EPE'18 ECCE Europe (http://www.epe2018.com) from September 17 to 21, 2018, in Riga is the 20th European Conference on Power Electronics and Applications. The conference features over 100 presentations and sessions by renowned companies from around the world and provides an overview of current research and solutions in electronics.

At the EPE Conference in Riga, Rohde & Schwarz (booth 13) will focus on challenges in power electronics and present a selection of oscilloscopes, probes and a power analyzer. For more information on test and measurement solutions for power electronics, visit: www.rohde-schwarz.com/ad/press/powerelectronics

Name
Type
Version
Date
Size
High resolution press picture
Type
Press pictures
Version
-
Date
Sep 17, 2018
Size
1 MB

Rohde & Schwarz

The Rohde & Schwarz technology group is among the trailblazers when it comes to paving the way for a safer and connected world with its leading solutions in test & measurement, technology systems, and networks & cybersecurity. Founded more than 85 years ago, the group is a reliable partner for industry and government customers around the globe. On June 30, 2020, Rohde & Schwarz had around 12,300 employees worldwide. The independent group achieved a net revenue of EUR 2.58 billion in the 2019/2020 fiscal year (July to June). The company is headquartered in Munich, Germany.


R&S® is a registered trademark of Rohde & Schwarz GmbH & Co. KG.
All press releases, including photos for downloading, are available on the internet at www.press.rohde-schwarz.com.

リクエスト情報

ご質問や詳細な情報のご要望などがございましたら、こちらのフォームよりお気軽にお問い合わせください。担当者よりご連絡させていただきます。

次の手段によってローデ・シュワルツから情報を受信することを希望します。

マーケティング・パーミッション

詳細について

私は、このウェブサイトの出版物に記載されているRohde & Schwarz GmbH & Co. KGおよびRohde & Schwarzの法人および子会社が、
ここで選択した手段 (電子メールまたは郵便メール) を通じて、マーケティングおよび広告目的 (特別キャンペーンや値引きに関する情報など) で、私に連絡することに同意します。その内容は、電子計測、セキュリティ通信、モニタリングおよびネットワークテスト、放送およびメディア、そしてサイバーセキュリティ分野の製品やソリューションを含みますが、上記に限定されるものではありません。

お客様の権利

この同意表明は、件名が"Unsubscribe"の電子メールをnews@rohde-schwarz.com宛に送信することにより、いつでも取り消すことができます。これに加えて、今後の電子メール広告の購読を停止するためのリンクが、送信されるすべての電子メールに記載されています。個人データの使用と取り消し手順の詳細は、「プライバシーステートメント」に記載されています。

お問い合わせ内容が送信されました。 後ほどご連絡致します。
An error is occurred, please try it again later.