405 Results
EMC32-S: RF indicator while running an EMS test
FAQ: Why is it necessary to define a Test Template?
FAQ: How can I generate and Export a Test Rreport?
Rohde & Schwarz offer a option SMCV-KV14 to generate SDARS XM-Radio test wave forms with the vector signal generator SMCV100B. But the needed test wave forms will not be delivered with this option, so where can I get the wave forms?
Connection of DUT and Link partner with test fixture RT-ZF2
FAQ, How to add a Graphic for Reverse Power to a Test
Open an exiting Test and add a new Limit Line
Two-Line V-Network Fails an Insulation Test. Why?
FAQ: Stop a Measurement, Save the Test and Continue the Measurement Later.
CMWrun Settings for external Interfer usage in Bluetooth LE Test Plans.
Add Limit Line to existing EMC32 Test to create a new list of critical frequencies
How can offline logs analyzed with CMW Mars message viewer tool for existing test runs that are saved on the CMW.
For radiated emissions test I would like to change the antenna factors to another antenna. Would it be possible to get a step by step guide as to how to create a new radiated emissions test using my EMI Test Receiver receiver with a new antenna?
How can a WLAN IEEE 802.11p be configured to be generated with WinIQSIM2 ?
In the Graphics of a Test, is it possible to make the Legend is always on? So we don't need to insert it, every time the Test is finished?
I am using EMC32 with EMI Auto Test EMC32-K10 and Test Receiver ESCI. The issue is I cannot perform final measurements with the detector CISPR AV.
There is only one simple test file for DAB installed as default on the SMCV100B. But to simulate realistic DAB signals with different codec and content more test files are nessessary.
Using my Turntable the Final Adjustment works on full range (from -180 to +180°) , also if I have defined a "predefined range" of 60°-
If a CMWrun test plan script has been fished the AC power of a CMW500 / CMW290 / CMW270 should be shut down automaticly.
Correction Column in EMC32-EB Final Results
Setting a CMW as a Bluetooth LE packet Generator
Diffent from the defaults, I would like to perform a disturbance Power test from eg. 300 to 500cm
How can the external attenuation values be configured and embedded in the CMWRun test sequences?
Is it possible to set up an IP peer to peer test using CMW500 between a corporate network and one EUT attached to an LTE cell?
I noticed that not all options of the Test Receiver are shown in ELEKTRA Device List. For example, option FSL-B7 is not displayed in Device List. Does that matter?
R&S®RTP-K101: Compliance test for USB 3.2 Gen 1&2 - Fact Sheet Brochures and Data Sheets
I have ELEKTRA dongle connected to my PC, but some of my devices from Device List are missing. Because of this I would like to simulate my Test, but the button "Simulate" is missing after Device Check.
I recently exported the results table from a test, and realized it had been truncated at line 65535. I tried a few more times, but the result was the same. What is the reason for the limitation?
We have installed our test system with EMC32 and all devices, but NRP2 can not be set to physical from EMC32 using LAN interface.
I would like to be sure about the high impedance state of a dedicated channel for my power supply unit. Do you have a process to test and to ensure that? Can you also please explain, how the high impedance mode works?