Application Notes

Automatic Spectrum Clearance in LTE and 5G mobile networks

RF interference is one of the largest contributors to poor network performance. It shows up in dropped calls and low data throughput rates. Traditionally, interference hunting means you get a list of sites with bad performance from an OSS. This defines the areas for interference hunting quite well.

If, however, the problem remains after attempts at mitigation, it could be because other sources often mask symptoms of RF interference. Usually the strongest masking is due to the overlap between the interference signal and your network's signals. Analysis could involve complete cities or even countries, an error-prone task when using traditional spectrum analyzers and/or portable receivers and one that consumes a significant amount of time and budget.

A more automated solution for larger areas can make the effort involved more manageable. The Rohde & Schwarz network scanner family (R&S®TSME, R&S®TSMA and R&S®TSMW) plus the network problem analyzer (NPA) feature of the R&S®ROMES4 measurement software is such a solution. It allows you to perform a fast drive test with a fleet of cars and collect spectrum data for your targeted or even complete network area in next to no time. Back at your office, the NPA tells you where to send dedicated interference hunting teams with an analyzer or receiver to track down the source of interference. This paper introduces the approach in detail.

Name
Type
Version
Date
Size
Automatic Spectrum Clearance in LTE and 5G mobile networks | 1MA293
Type
Application Note
Version
1e
Date
24-May-2019
Size
4 MB