Description
When I use the limit line function on my ZNB, I usually switch off the "Show Limit Fails Symbol". This leads to suppression of these bold dots over the measurement curves:
ZNB Limit Line display difference on screen and while printing
However if I print that screen using one of the functions, all these dots are back again.
What can I do to avoid that difference between my screen and the print?
Resolution
There are two different settings for the display and the print function.
The best way is to define a user scheme for the display first by pressing.
[Display] - (Config) - (Define User Color), change the desired settings and close the box.
The changes now are stored in the current user setup. If you wish to recall it later again, please also use the Save and Recall functions.
After this setting is done, please change to the printer setup suing the menu File / (Wrench symbol) Print...:
Change to the Printer tab and choose the User Defined Color Scheme.
This will now lead into the desired printout.
Additional information: The display will not change on the screen while the analyzer is in Single Sweep mode. However the printed information will be correct.
