The Rohde & Schwarz documents & articles offer a variety of information material.
EMC32-S: Immunity level not reached - abort EMS scan
EMC32-S: Is it possible to abort an EMS scan when the EMC32 goes below a certain immunity level, e.g. if the amplifier fails?
Yes, you can do that. In the EMS Scan Template, on the Levelin...
EMC32-S: Pulse train support in EMC32
I am using EMC32. How can I configure a test template with the SMB100A (including SMB-K27) or the SMF100A (including SMF-K27) to generate pulse trains for my EMC32 application?
The pulse train software ...
FSx doesn't recognize active probe RT-ZS30
We have an issue with our FSx and the RT-ZS30 probe: the FSx does not automatically recognize the probe Could you please help us to solve this blocking issue.
You can work with the RT-ZS30 connec...
EMC32-S: Amplifier properties, reverse coupling path attenuation
In my hardware setup, I have two power meters connected to the amplifier, one for the amplifier FWD path and one for the amplifier REV path. When I look at the amplifier properties, I can only define the att...
Improve the calibration procedure for different setups
I have to perform a measurement with different settings (power, bandwidth, ...). If I use the microwave prober with an on-chip calibration substrate to perform a TOSM calibration, it would take a very long time becau...
How to connect HMExplorer to the instrument
My HMExplorer does not connect to the instrument
Error when adding a device. The interface could not be opened.
The latest version of the HMExpl...
Changing virtual COM port to use field probe with EMC32
We are using EMC32 software for EMS measurements. Currently we have difficulties integrating a field probe. We cannot change the COM port of the field probe's USB/serial adapter and therefore cannot use the field pro...
Web interface allows several users to control the HMP
The HMP is used by two persons at the same time. One is using channel 1 and the other is using channel 2. Are they able to remotely control their channels at the same time via the web interface?
RF indicator while running an EMS test
I want to be sure that RF from the generator is switched off when my notification message is displayed. In EMC32, I see two RF indicators when the message is displayed. Which of the indicators shown in EMC32 is correct?
FSW: Check for SYNC error via remote control
I am using the 3GPP application. When the FSW is not synchronized to the signal, there is a big red bar with 'Sync failed' at the bottom of the display. How can I check for this via remote control?
To enable us to optimize our website for you, cookies may be saved on your computer when you visit our website in order to analyze website browsing habits.More Information