Learn how to configure Rohde & Schwarz products to fit your application.
10 Results
Active, high-impedance probes can be connected to spectrum analyzers, providing a practical and highly precise measurement solution to overcome an otherwise cumbersome RF testing issue. This application note provides information on how to use oscilloscope probes in RF measurements using spectrum analyzers
English - 4 thg 7, 2023
Bluetooth
English - 5 thg 6, 2019
The document gives an overview and user guide about a link budget calculator for the main components of a basic OTA system. Accomopanied by an Excel sheet containing the Link Budget Calculator.
English - 19 thg 3, 2019
R&S®Forum for Instrument Remote Control
English - 28 thg 6, 2018
This application note shows how to use Rohde & Schwarz signal generators and analyzers for testing early 5G New Radio components, chipsets and devices. Methods for easy creation and analysis of custom OFDM are explained.
English - 23 thg 10, 2017
Rohde & Schwarz signal and spectrum analyzers accurately measure the noise figure in the millimeterwave frequency range using the Y-factor method.
English - 17 thg 7, 2017
This application note describes how to use the R&S CMW platform to perform the measurements defined in Bluetooth test specification version 5.
English - 19 thg 6, 2017
This white paper provides an overview of test solutions addressing current and future requirements for antenna verification.
English - 11 thg 11, 2016
This application note focusses on signal measurement using the R&S®RTO digital oscilloscopes ant the output of I/Q data for processing.
English - 18 thg 10, 2016
English - 14 thg 7, 2016
