Downloads

Describes the significance of the Bit Error Rate (BER) parameter for signal analysis; How the FSW VSA application calculates the BER and determines bit errors; How this knowledge can be used to obtain correct modulation accuracy results

English - 11 thg 11, 2025

Describes how to determine important signal characteristics (e.

English - 11 thg 11, 2025

Full RF component characterization using a single RF connection.

English - 10 thg 11, 2025

Level Range Extension of a Vector Signal Generator Using an External Amplifier

English - 12 thg 3, 2025

Creating Satellite Fading Scenarios with the R&S Space Nexus

English - 3 thg 2, 2025

Verify O-RAN radio units

English - 8 thg 5, 2024

Integrated sensing and communication (ISAC) brings the future to life in 6G

English - 11 thg 3, 2024

Optimize your signal and spectrum analyzer to address the most stringent EVM requirements

English - 16 thg 11, 2023

Perform DPD on a vector signal generator for improved EVM performance

English - 28 thg 8, 2023

Active, high-impedance probes can be connected to spectrum analyzers, providing a practical and highly precise measurement solution to overcome an otherwise cumbersome RF testing issue. This application note provides information on how to use oscilloscope probes in RF measurements using spectrum analyzers

English - 4 thg 7, 2023

Get insights into small cell testing aspects throughout the product life cycle with particular focus on production test solutions for FR2.

English - 19 thg 6, 2023

English - 10 thg 11, 2022

This application note provides some technical background on how to optimize the measurement of one of the key performance parametersof 802.11be WLAN transmitters.

English - 6 thg 9, 2022

English - 24 thg 1, 2022

This application note, introduces an example of automated testing of 5G UE PA with R&S signal generator, signal and spectrum analyzer, vector signal explorer software, power meter along with power supply.

English - 9 thg 8, 2021

This application note is based on collaborative work between MathWorks® and Rohde & Schwarz. The focus is on linearization of a non-linear device, in our case the RF power amplifier.

English - 5 thg 8, 2021

This application note provides information how to perform spectral emission measurements on UWB signals with spectrum analyzers using wide bandwidth RBW filters.

English - 28 thg 6, 2021

The R&S®FSW and R&S®SMW200A are leading hardware solutions for 5G NR base station tests - set up all required parameters in no time with just a few clicks.

English - 25 thg 5, 2021

The R&S®FSW signal and spectrum analyzer facilitates swept spectrum analysis of next generation SARs with true preselection, finer range resolution and image rejection.

English - 16 thg 4, 2021

This application note belongs to a series of application notes which explains how to test EW receivers at RF in the lab with commercial, off-the-shelf signal generators and software.

English - 23 thg 3, 2021

This application note describes how all mandatory RF transmitter tests according to Release 16, can be performed with signal or spectrum analyzers from Rohde & Schwarz.

English - 27 thg 1, 2021

In order to make it easier to monitor the use and status of instruments, some devices offer the software option Health and Utilization Monitoring Service (HUMS). HUMS provides all necessary information about the health status and utilization over time in many details.

English - 11 thg 1, 2021

This application note describes how all mandatory RF receiver tests can be performed quickly and conveniently with signal generators from Rohde & Schwarz.

English - 2 thg 12, 2020

The R&S FSW signal and spectrum analyzer measures and analyzes time sidelobes to optimize compressed radar signals as well as radar hardware components and systems.

English - 22 thg 10, 2020

This application note provides guidance on the use of the software option, both for direct control and programming via the touchscreen, and for remote control using SCPI.

English - 13 thg 7, 2020

3GPP defines the Radio Frequency (RF) conformance test methods and requirements for 5G NR Base Stations (BS) in the technical specifications TS 38.141.

English - 30 thg 6, 2020