Pesquisa de Artigos e Documentos

Describes all functions and remote control commands of the R&S®NRQ6.

English - 2 de jun. de 2025

Provides the basic information required for remote control connections via SCPI.

English - 16 de jul. de 2025

Provides the information required to prepare the power sensor for use and start working.

English - 7 de fev. de 2025

Provides the information required to install a software option.

English - 3 de mai. de 2022

This application sheet deals with a particular aspect of the R&S®NRQ6 functionality.

English - 26 de jan. de 2022

English - 18 de jun. de 2025

English - 14 de jan. de 2022

English - 17 de set. de 2025

This application note supplies a free of charge software tool that can be used to add or subtract an arbitrary number of powers. In addition, the software can be used to convert power and voltage units from the linear to the logarithmic scale (and vice versa), convert linear power and voltage ratios to decibels, and convert a VSWR to other reflection quantities.

English - 10 de dez. de 2018

For component tests, it can be required to set the DUT output power to a specific value before starting the test of a test sequence.

English - 10 de out. de 2019

English - 4 de jun. de 2025

This application sheet deals with a particular aspect of the R&S®NRQ6 functionality.

English - 26 de jan. de 2022

This application sheet deals with a particular aspect of the R&S®NRQ6 functionality.

English - 26 de jan. de 2022

This application sheet deals with a particular aspect of the R&S®NRQ6 functionality.

English - 10 de out. de 2019

Provides information on security issues when working with the power sensors in secure areas.

English - 10 de abr. de 2026

5G New Radio (NR) FR1 MIMO or beamforming downlink signal analysis especially the phase measurement of each MIMO layer and the determination of the phase difference between the MIMO layers are essential for the 5G base station product design.In this application note, it describes two test solutions from R&S® to cope with the 5G FR1 downlink MIMO signal analysis challenges either using R&S®RTP/RTO oscilloscope or R&S®NRQ6 frequency selective power sensor as RF frontend to capture the signal and together with R&S®VSE as post-processing tool for the IQ analysis.The aim of this application note is to walk the user through the necessary steps on both test solutions to enable the 5G FR1 downlink MIMO signal analysis.It is assumed that the reader has certain pre-knowledge of 5G NR physical layer. In case a refreshment is needed, please refer to the for further reading.

English - 26 de jun. de 2020

During development of MU-MIMO antenna arrays, the beamforming algorithms undergo steady revision. Whether used in regression testing or verification of newly introduced features, fast beamforming verification helps to speed up R&D for beamforming antennas and improve performance of your product.

English - 7 de jul. de 2020