Centre de téléchargement

French - 8 août 2022

English - 8 août 2022

This white paper summarizes the technology options for supporting voice and short message service (SMS) in LTE, including circuit switched fallback (CSFB), SMS over SGs, and voice over LTE (VoLTE).

English - 11 mai 2011

Modern radio communication systems have to provide higher and higher data rates. As conventional methods like using more bandwidth or higher order modulation types are limited, new methods of using the transmission channel have to be used. Multiple antenna systems (Multiple Input, Multiple Output – MIMO) gives a significant enhancement to data rate and channel capacity. This application note gives an introduction to basic MIMO concepts and terminology and explains how MIMO is implemented in different radio communications standards.

English - 2 juil. 2009

This document describes how a Windows®-based R&S® T&M instrument is remotely operated by an Android™ tablet as if working on it locally. Step-by-step procedures are provided for setting up and configuring the T&M instrument and the tablet. On the tablet, a special App implements the Windows® 'Remote Desktop' functionality. T&M instrument and tablet are connected via WLAN (also called Wi-Fi network).

English - 22 août 2013

The R&S®CMW-B400B audio board offers the flexibility to measure and quantify audio applications with the R&S®CMW270/280/500 radio communication testers.

English - 20 juin 2013

Software tools allow to make the control of T&M instruments more convenient. The adoption of the following tools for Windows®-based T&M instruments is described: ● Synergy:One mouse and one keyboard control a group of T&M instruments ● CamStudio:Video clips of the display of a T&M instrumentare recorded during operation

English - 13 juin 2013

This white paper introduces a novel attribute based architecture for VXIplug&play instrument drivers. The presented architecture uses the attribute based concept of IVI-C instrument drivers to introduce a two-layer design for VXIplug&play instrument drivers. Moreover the use of attributes is shown for the Rohde & Schwarz Spectrum Analyzer (rsspecan) instrument driver.

English - 30 nov. 2012

This document describes how a Windows®-based R&S® T&M instrument is remotely operated by an Apple iPad as if working on it locally. Step-by-step procedures are provided for setting up and configuring the T&M instrument and the iPad. On the iPad, a special App implements the Windows® 'Remote Desktop' functionality. T&M instrument and iPad are connected via WLAN (also denoted as Wi-Fi network).

English - 28 mars 2013

This application note discusses WLAN standard IEEE 802.11n. It first describes the most important amendments to previous releases and the ambitious new measurement tasks. Then, it describes how to deal with these tasks using Rohde & Schwarz instruments. The main focus here is on transmission over several TX and RX antennas (MIMO). Building multistandard signals using Rohde & Schwarz generators is also described. Screenshots from the analyzer taken on 802.11n signals complete the document.

English - 25 avr. 2013

This document describes Bluetooth Low Energy RF over-the-air RX and TX measurements using advertising channels for communication with Bluetooth Low Energy devices.With the R&S®CMW-KD611 software option, the R&S CMW tester is able to perform a large number of Bluetooth Low Energy RF tests without operating in the Direct Test Mode.The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Rohde & Schwarz is under license.

English - 14 déc. 2020

The use of Rohde & Schwarz device drivers under VEE software is not complicated. However, a number of factors are involved, the errors that occur are often difficult to diagnose. This application provides easy and detailed support for installation and troubleshooting using National Instruments or Agilent GPIB boards.

English - 20 déc. 2012