Downloads

The ARB Toolbox is an easy-to-use, feature packed software package that is used for many ARB waveform related tasks.

English - 13 dic 2018

Describes all instrument functions and remote control commands, including measurement and programming examples, for the base unit.

English - 11 nov 2025

R&S®Forum for Instrument Remote Control

English - 28 giu 2018

Provides the information required to prepare the instrument for use and start working.

English - 11 nov 2025

R&S®VISA is a standardized software library that allows fast communications over diverse interfaces with a wide variety of T&M instruments that are detected on the network from PC applications.

English - 26 mag 2020

RSCommander is a versatile software tool for a wide range of Rohde & Schwarz spectrum-, network analyzers, signal generators and oscilloscopes. It allows for automatic instrument discovery, making screenshots, reading traces, file transfer and simple script creation.

English - 24 dic 2017

Provides the basic information required for remote control connections via SCPI.

English - 11 nov 2025

The R&S®FSQ signal analyzer provides the high dynamic range needed to accurately measure the ON/OFF power of your transmitter in accordance with 3GPP TS 36.141.

English - 17 gen 2017

This application note gives a short introduction to NB-IoT (Internet of things) and shows the easy measurements with Rohde & Schwarz instruments like transmitters and test receivers.

English - 30 giu 2017

Full RF component characterization using a single RF connection.

English - 10 nov 2025

The R&S®FSW signal and spectrum analyzer is a high-performance instrument capable of measuring many key system and component parameters. Using the bit error rate (BER) functionality of the R&S®FSW-K70P option, the raw data error performance of a component or system can be accurately determined.

English - 26 set 2018

Hints and Tricks for Remote Control of Spectrum and Network Analyzers

English - 19 ago 2014

This application note describes how transmitter (Tx) tests (TS25.141 Chapter 6) can be performed quickly and easily by using signal and spectrum analyzers from Rohde & Schwarz.

English - 21 ott 2014

Digital pre-distortion (DPD) is a common method. This article describes an approach to generate a pre-distorted signal based on a hard-clipper.

English - 13 set 2017

In this paper we will review the basics of spurious measurements and how the parameters used can affect the detection performance.

English - 14 lug 2017

Noise Power Ratio is a tool for WinIQSIM™ to generate noise power ratio stimulus signals and measure the resulting noise power ratio of a device.

English - 6 nov 2015