70 Results
This document provides the technical specifications of the R&S®ZNB vector network analyzer.
Outstanding speed, dynamic range and ease of operation
R&S ZNB Vector Network Analyzer (First Generation) - Specifications
What can I do to avoid that difference between my screen and the print?
Can the option ZNB-B10 be installed in the field?
Nonlinear applications using Rohde & Schwarz vector network analyzers - Product Flyer
The user is requested to move results from a Network Analyzer to the controller PC or to a network drive.
Efficient analysis of power and signal integrity and EMC - Flyer
I would like to use the ZNB as a signal generator. I need a CW signal on port 1 and port 3 with different frequencies. How can I get that?
ZNB - several channels with external trigger
Remote Desktop screen size of ZNB/ZND
ZNB - How to disable Sweep Position Display Symbols
ZNB: Power off at sweep end possible?
ZNA/ZNB: Export all mixed mode S-Parameters
I have used my TRL calibration kit with my ZVA before. Now I want to use also with my ZNB. But when I try to load the data of the calibration kit into the ZNB, the above error message is shown.
ZNB - print to file command does not work anymore
ZNB/ZND - wrong connector type shown at Cal Unit Characterization
ZNA, ZNB, ZND - Power off after stop of the Sweep?
Is there a way to use the hard keys when using the ZNB via Remote Desktop connection? On my unit I only see the standard menu to the lower left side of the device, but have no access to the "master keyboard"
I want to do a calibration with 75 Ohms at the ZNB/ZND/ZVA. Do these VNAs accept the auto cal unit ZV-Z53 with 75 Ohms impedance?
How do I use the driver correctly?
I have done a calibration and now I want to validate it with an automatic calibration kit. But it always fails. What is wrong?
When I start a calibration with an auto cal unit I get the following warning. What does that mean?
I got a calibration kit with a sliding match standard. But there are no correction values for the NWA supplied.
I am using the command “CONT:AUX:C x” to see when a channel is active. But the respective pin at the AUX connector does not switch to “high”.
How can I export the traces of a specific channel into one file, i.e. CSV?
ZNB, ASCII export of displayed trace values
I perform a calibration with remote commands. With the command to start the calibration sweep with a short standard I get this error message. What is the problem?