24 Results
Saving a screenshot to an USB stick with remote commands
What is the calculation base for the sample rate on my R&S RTA / RTM series scope when using FFT?
RTM/RTA: Measurement on several pulses of a train.
I use the oscilloscope in RUN continious mode. When I press "STOP" more than one acquisitions are shown. The waveforms are overlayed. Is there a way to prevent this?
I do RMS measurement on a signal after switching the channels. Even with *OPC? or *WAI the result is implausible: 9.91e+37 . How can I get a correct result?
Delta Time Accuracy Calculation for my Oscilloscope
With active FFT it seems that the timebase setting can not be changed. Is there a way to do that?
How can I copy the screen shots from the internal memory to an USB stick?
I have compared passive and active probes. It seems that the noise with active probes is higher. What is the reason and what can I do to reduce the noise?
I would like to measure the voltage at a certain time of a captured waveform. Do I need to use the cursor function? May I ask for the SCPI commands?
I am using the burst function of the function generator. But I can not find the remote command to set the burst to "manual".
I have saved some important screenshots in /INT/SCREEN path. Now I want to save/copy these data on a USB key or my PC.
I want to use the "Remote Display" function of the Instrument View software. Instead of the screen I just see a "white" area. My PC is connected via USB. How can I use it?
Programming examples for oscilloscopes.
RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA, RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA,
No synchronisation in Auto Trigger Mode
RTB/RTM/RTA - reduce Stop Frequency at FFT
When I set the frequency of the arbitrary generator to 10 KHz, the frequency of the output signal is 120 KHz. What is wrong here?
Configuring the Probe Adapter RT-Z2T with remote commands
I want to install the RTB / RTM / RTA into a rack and I use the rackmount kit "ZZA-RTB2K". Is the ground of the oscilloscope then connected to the frame of the rack?
LabView Driver rsrtx - Range of Configure Trigger Channel Level
Calibration certificate? Calibration certificate; ZNL; ZNLE; FTP1000; RTH1000; RTB2000; ZPH; FPH; FPC1000; RTM3000 Calibration certificate? Calibration certificate; ZNL; ZNLE; FTP1000; RTH1000; RTB2000; ZPH; FPH; FPC1000; RTM3000
How can I switch between the input impedance of 50 Ohm and 1 MOhm by using SCPI command.
I want to set the acquisition mode to Average + HR using SCPI commands. But I can not find the right command in the manual.