25 Results
How can offline logs analyzed with CMW Mars message viewer tool for existing test runs that are saved on the CMW.
Is it possible to set up an IP peer to peer test using CMW500 between a corporate network and one EUT attached to an LTE cell?
CMsquares download file not available in R&S Installation Manager
During a CMWrun test my DUT fails on delivering isolated measurements using CMW270/290/500.
Installation of CMWcards is made on a external PC that should control the CMW mobile radio tester via LAN interface. But also the PC and the CMW are connected to the same LAN the remote connection do not work and the resource check showed "not connected".
My SW needs to validate its usage by means of a license available in a Dongle for testing with CMW 270/290/500, which are the requirements?
ATE ATT v17.30 patch status and known issues
CMW500/290/270: No more WLAN signaling function after WLAN firmware update
This article describes the typical questions and considerations to be done while handling SIM Cards and using R&S instruments such as for example CMW500.
How to configure a external trigger at CMW500, CMW290, CMW270 to synchronize with LTE signal time frames
During the call setup with VoLTE/VoWiFi with EVS voice codec the bandwidth is negotiated. How can the bandwidth be setup and how will it be shown in the CMW user interface?
Problems during WLAN measurement
CMWrun Settings for external Interfer usage in Bluetooth LE Test Plans.
LTE UE capabilities Interpretation of Bandwidth Combination Set values shown in CMW Callbox
CMW500/2xx intenal fan settings to reduce noise CMW500/2xx intenal fan settings to reduce noise
In commercial mobil networks the operator disables the access to data services when a mobile device use a not allowed APN. How can that be tested in the CMW and what has to be setup?
How to get Wireshark log files for IMS (VoLTE, VoWiFi) when using CMW500/CMW290
How can the CQI (Chanel Quality Identifier) from UE and coresponding 3GPP specified mapping to Modulation and TBS be tested?
The CMW500/2xx shows a resource conflict in this situation when using in parallel the RFxCOM port and the RFxOUT port of the same RF-frontend.
Setting a CMW as a Bluetooth LE packet Generator
DTMF analysis on CMW500 and CMW290
Bluetooth Reciver Intermodulaton- and Blocking Performance tests fail with every DUT when using an external signal generator to generate the interferer signals.
I have a file on my device. How can I get it in a simple way to my PC?
If a monitor is connected to the DVI ports of the CMX the maximal resolution is 800 x 600 pixel. How can that resoltuion be increade for a external monitor?
It is required to run two simultaneous NB IoT Signaling tests in parallel. Is this possible for a CMW call box tester?