Manual testing of typical transmitter and receiver parameters

Manual testing of typical TX and RX parameters

A range of typical transmitter and receiver parameters need to be tested to ensure compliance with the essential requirements covered in article 3.2 of the RED. While turnkey test systems perform all test requirements automatically, each transmitter and receiver parameter can also be tested manually.

Rohde & Schwarz offers a wide range of suitable signal generators to generate, for example, the main and interfering signals as well as signal analyzers that offer realtime functionality. Some tests require additional test instruments and accessories such as filters, combiners and attenuators.

ETSI Recommendation EG 201 399 lists the typical radio transmitter and receiver parameters required for radio equipment. In general, the RED addresses receiver and transmitter parameters in a more balanced way than the R&TTE Directive.

Examples of how to perform such parameter tests with Rohde & Schwarz test instruments will be added soon. Check this site frequently or contact Rohde & Schwarz for further details.

Typical transmitter tests in line with previous (R&TTE) and new (RED) directive

In order to ensure that radio equipment uses the radio spectrum effectively, the RED requires that when the transmitter is properly installed, maintained and used for its intended purpose it generates radio waves emissions that do not create harmful interference, while unwanted radio waves emissions generated by the transmitter (e.g. in adjacent channels) with a potential negative impact on the goals of radio spectrum policy should be limited to such a level that, according to the state of the art, harmful interference is avoided. To ensure proper transmitter operation, the RED recommends the following test methods:

  • Frequency accuracy and stability
  • Transmit power
  • Adjacent-channel power
  • Spurious emissions
  • Intermodulation attenuation
  • Transient behavior
  • Modulation accuracy
  • Duty cycle

Typical receiver tests in line with new directive (RED)

Although receivers do not generally cause harmful interference, reception capabilities are an increasingly important factor in ensuring the efficient use of radio spectrum by way of an increased resilience of receivers against harmful interference and unwanted signals on the basis of the relevant essential requirements of Union harmonization legislation. To ensure proper receiver operation, the RED recommends the following test methods:

  • Dynamic range and sensitivity
  • Co-channel rejection
  • Adjacent-channel selectivity
  • Spurious response rejection
  • Intermodulation response rejection
  • Blocking / desensitization
  • Spurious emissions
  • Multipath sensitivity

Related products

Signal generators

Product information

Signal & spectrum analyers

Product information

Sign up for our newsletter

Stay up to date with the latest news, information and resources

Sign up for our automotive newsletter

Request information

Do you have questions or need additional information? Simply fill out this form and we will get right back to you.

Marketing permission

Your request has been sent successfully. We will contact you shortly.
An error is occurred, please try it again later.