Login or register to gain full access to the Knowledge+ platform!
I want to create an account
I already have an account
The focus is on understanding as early as possible in the design process performance enhancements through linearization of non-linear devices.
This video gives a short introduction into conducted EMI pre-compliance measurements using the EMI Measurement Application K54.
Digital pre-distortion (DPD) is a common method. This article describes an approach to generate a pre-distorted signal based on a hard-clipper.
Learn more about Doherty amplifier and measurement-aided development with solutions from Rohde & Schwarz.
This webinar helps decision makers as well as design and test engineers understand the different risk categories and test concepts for wireless coexistence ...
To capture 5G signals in TDD network for spectrum analysis measurements can be quite challenging. For example to measure the occupied bandwidth and spurious ...
The video shows the R&S®FSVA signal and spectrum analyzer from Rohde & Schwarz.
At the European Microwave Week 2011, Rohde & Schwarz presented the new R&S®SMZ frequency multipliers which offer precise and adjustable output levels from ...
The FSVR is the first spectrum analyzer with two analysis modes: conventional (heterodyne) spectrum analysis and real-time (FFT) analysis.
Ensure fast, automate and reproducible testing results by using the R&S®SMW200A and R&S®FSW. Increase your test throughput by automatizatio.
With the R&S®SMW200A and the R&S®FSW realistic NPR measurements can be performed by using modulated signals. Increase the performance of your amplifier.
Learn how to perform qualification measurements on satellite components and systems with the R&S®SMW200A and R&S@FSW .
Get to know a direct measurement method for antenna array calibration to correct for relative amplitude and phase offsets using the R&S®SMW200A and ...
Learn more about the theoretical background of antenna array calibration and get to know various methodologies including direct and indirect measurements.
Gain transfer method is an example of OTA test system calibration. Learn how to use this method to carry out repeatable and reliable OTA measurements.
This Video shows most versatile and easy envelope tracking test setup presented at GSMA MWC 2014
This document provides information on the techniques used to calibrate the FSMR3000 signal source. It also describes the process used to remove measurement ...
This application note demonstrates the use of the FSMR, including the Cross-correlation option (R&S®FSMR3-B60), to measure the Phase Noise characteristics of ...
Linking EDA design simulation and hardware testing to enable an easy, straightforward process flow and first-pass design.
This application note, introduces an example of automated testing of 5G UE PA with R&S signal generator, signal and spectrum analyzer, vector signal explorer ...
This application note is based on collaborative work between MathWorks® and Rohde & Schwarz. The focus is on linearization of a non-linear device, in our case ...
This application note provides information how to perform spectral emission measurements on UWB signals with spectrum analyzers using wide bandwidth RBW filters.
This application note belongs to a series of application notes which explains how to test EW receivers at RF in the lab with commercial, off-the-shelf signal ...
Measuring the power supply noise rejection (PSNR) requires accurate generation and leveling of artificial, sinusoidal disturbances and measurement of resulting ...
This application note provides guidance on the use of the software option, both for direct control and programming via the touchscreen, and for remote control ...
This application note describes two test solutions from R&S® to cope with the 5G FR1 downlink MIMO signal analysis challenges either using R&S®RTP/RTO ...
This application note describes a technique to perform the noise figure measurement with FSW-K30 on lossy devices like attenuators with high loss in front of the ...