20 Results
HMExplorer - Port for network connection
I have a R&S Laboratory Power Supply and could find not find a way to make it switch on the output automatically after mains comes up. How can this be done?
HMP Series accessoires
Is there a way to test the fans of my HMP Power supply?
HMP Series FW Update - Error Message right after powering up the device
I want to control my HMP using the RS-232 port on the HO720. Unfortunately i do not get any response from the device.
HMExplorer installation fails with .dll problems
Web interface allows several users to control the HMP
I tried to measure the Voltage Noise of my power supply unit which is specified to the following values. My results have been much higher and I sent in the device for alignment/calibration. After getting it back I still gather the same results. Can you explain how to perform such a measurement?
I tested a two channel parallel setup with my HMP series power supply and surprisingly get higher current measured as expected.
I own a R&S HMP series power supply. Can you please let me know how I can read out the firmware versions - specially for the interface card?
I want to expand the output power of my PSU using some channels in parallel. How can I use sensing in that case?
Serial and Parallel Channel operation of Power Supply Units (PSUs) in general
HMP Series Fan Test
How to connect HMExplorer to the instrument
My HMExplorer script is not running while all commands are OK, why?
In the datasheet of the HMP series i could not find any information concerning the MTBF time of the relay switching the output power. Do you have any further information available?
How to setup the Hameg HMP2000 and 4000 Series for TCP/IP RAW socket connection using NI VISA
When I try to update my HMP series Power Supply, the updater tells me "Wrong or no device detected! - Process abort". What can I do to make it work?
Best way to switch off the HMP series power supply