Power integrity measurements with R&S®RTM3000 and R&S®RTA4000 oscilloscopes

Your task

Measuring noise and ripple on power rails with small voltages and increasingly tighter tolerances is a challenge for oscilloscopes. Using a standard 500 MHz passive probe with a 10:1 attenuation results in additional measurement noise, causing overstated peak-to-peak voltage measurements and masking signal details as shown below.

Passive probes with 1:1 attenuation have less noise, but are bandwidth limited to around 35 MHz. They miss higher frequency content that may be riding on the power rail and may understate peak-to-peak-voltages.

Rohde & Schwarz solution

Combining a low-noise oscilloscope with a power rail probe, developed uniquely for measuring power rails, provides a measurement system that delivers measurements that are more accurate. The R&S®RT-ZPR20 active probe with a 1:1 attenuation ratio has very little noise and enough bandwidth to not attenuate critical signal content.

When combined with an R&S®RTA4000 or R&S®RTM3000 oscilloscope, the R&S®RT-ZPR20 power rail probe provides the following benefits:

• The probe’s 1:1 attenuation provides minimal noise for a system noise of less than 500 μV (at 1 GHz bandwidth and 10 mV/div)
• With ±60 V of built-in offset, users can center and zoom in a wide variety of DC rail voltage standards without worrying about how much built-in offset the scope has. The offset eliminates the need to use AC coupling or DC blocking capacitors, which impede the ability to see true DC values and drift
• High-frequency transients and coupled signals are isolated. The probe’s rated bandwidth is 2 GHz. When used with an R&S®RTA4000 or R&S®RTM3000, overall bandwidth is set by the oscilloscope bandwidth
• 50 kΩ DC input impedance minimizes loading, so DC values remain accurate
• An integrated 16-bit R&S®ProbeMeter provides a simultaneous five-digit readout of each power rail’s DC value