Domanda
Come faccio a rilevare il completamento del 400° sweep tramite controllo remoto?
Come faccio a rilevare il completamento del 400° sweep tramite controllo remoto?
Questo è un programma che contiene i comandi che rileveranno il completamento del
400° sweep:
REM Initiate an average sweep over 400 sweeps
FSx: INIT:CONT OFF
FSx: DISP:TRAC:MODE AVER
FSx: SWE:COUNT 400
FSx: SWE:TIME 0.1
FSx: *CLS
REM Con *OPC avviata operazione completa
FSx: INIT;*OPC
REM The next line will be repeated until the operation complete bit is set
WHILE FSx: *ESR? <> 1