Downloads

The ARB Toolbox is an easy-to-use, feature packed software package that is used for many ARB waveform related tasks.

Englisch - 13.12.2018

Describes all instrument functions and remote control commands, including measurement and programming examples, for the base unit.

Englisch - 11.11.2025

R&S®Forum for Instrument Remote Control

Englisch - 28.06.2018

Provides the information required to prepare the instrument for use and start working.

Englisch - 11.11.2025

R&S®VISA is a standardized software library that allows fast communications over diverse interfaces with a wide variety of T&M instruments that are detected on the network from PC applications.

Englisch - 26.05.2020

RSCommander is a versatile software tool for a wide range of Rohde & Schwarz spectrum-, network analyzers, signal generators and oscilloscopes. It allows for automatic instrument discovery, making screenshots, reading traces, file transfer and simple script creation.

Englisch - 24.12.2017

Provides the basic information required for remote control connections via SCPI.

Englisch - 11.11.2025

The R&S®FSQ signal analyzer provides the high dynamic range needed to accurately measure the ON/OFF power of your transmitter in accordance with 3GPP TS 36.141.

Englisch - 17.01.2017

This application note gives a short introduction to NB-IoT (Internet of things) and shows the easy measurements with Rohde & Schwarz instruments like transmitters and test receivers.

Englisch - 30.06.2017

Full RF component characterization using a single RF connection.

Englisch - 10.11.2025

The R&S®FSW signal and spectrum analyzer is a high-performance instrument capable of measuring many key system and component parameters. Using the bit error rate (BER) functionality of the R&S®FSW-K70P option, the raw data error performance of a component or system can be accurately determined.

Englisch - 26.09.2018

Hints and Tricks for Remote Control of Spectrum and Network Analyzers

Englisch - 19.08.2014

This application note describes how transmitter (Tx) tests (TS25.141 Chapter 6) can be performed quickly and easily by using signal and spectrum analyzers from Rohde & Schwarz.

Englisch - 21.10.2014

Digital pre-distortion (DPD) is a common method. This article describes an approach to generate a pre-distorted signal based on a hard-clipper.

Englisch - 13.09.2017

In this paper we will review the basics of spurious measurements and how the parameters used can affect the detection performance.

Englisch - 14.07.2017

Noise Power Ratio is a tool for WinIQSIM™ to generate noise power ratio stimulus signals and measure the resulting noise power ratio of a device.

Englisch - 06.11.2015