Documents & Articles Search

The Rohde & Schwarz documents & articles offer a variety of information material.

Results 91 - 100 of 5562 *

Did you find what you're looking for? If not, repeat the search on our International Website

  • Driving of I²S Bus Components with Audio Analyzer UPD

    In contrast to standardized digital interfaces which are customary for communication between audio devices, diverse data formats are used between the internal modules of a particular device. The I²S interface developed by Philips has now been widely adopted for the latter. The data structure of this digital audio interface and the adaptation of Audio Analyzer UPD in the different operating modes of the I²S bus are described in this Application Note.

  • Safe debugging of embedded power supplies

    Embedded power supplies combine traditional power supply components with multiple sensors, processing and control logic as well as digital communications interfaces. Test equipment for debugging requires isolated input channels for measurements of hazardous voltages. Additional digital channels support the analysis of digital signals, while trigger and decode capabilities are essential for time-correlated monitoring of serial protocol-based communications interfaces.

  • Ease DOCSIS 3.1 CM and CMTS PHY testing

    The R&S®FSW signal and spectrum analyzer offers fast and easy-to-use transmitter testing for the demanding DOCSIS 3.1 cable modem (CM) and cable modem termination system (CMTS) requirements.

  • RF amplifiers from Rohde & Schwarz in accelerator physics

    Particle acceleration requires cavity resonators that are driven with high RF powers at defined frequencies. Rohde & Schwarz offers RF solid-state amplifiers for frequencies ranging from 9 kHz to 6 GHz, delivering CW power up to 80 kW.

  • A 1 MHz to 50 GHz Direct Down-Conversion Phase Noise Analyzer with Cross-Correlation

    A new phase noise test instrument covers the frequency range from 1 MHz to 50 GHz with direct down-conversion analog I/Q mixers and baseband signal sampling. The traditional PLL has been replaced by a digital FM demodulator for phase detection and frequency tracking. An additional AM demodulator enables concurrent measurement of phase and amplitude noise. The instrument can measure phase noise as low as -183 dBc/Hz with a 100 MHz carrier frequency and 10 kHz offset within two minutes.

  • Debug standard and proprietary serial buses in aerospace and avionic systems

    The R&S®RTE and R&S®RTO oscilloscope families from Rohde & Schwarz provide an in-depth tool for debugging custom and off-the-shelf serial buses for the avionics and aerospace industries.

  • R&S®CMWrun - IP throughput testing

    Sequencer Software Tool

  • R&S®CMWrun - In-device coexistence testing

    Sequencer Software Tool

  • Enabling smart macro network enhancements

    Rohde & Schwarz mobile network testing solutions enable operators to efficiently increase network capacity via hardware-related, capacity-enhancing features such as antenna tilt optimization, carrier aggregation, 4x4 MIMO and 6-sector sites.

  • Testing IoT designs with the R&S®RTO2000

    Focus RF Signal Analysis

Results 91 - 100 of 5562
Previous  5  6  7  8  9  10  11  12  13  14  15  Next
Thank you.

Your request was successfully sent!

We will get in touch with you soon.

Your Rohde & Schwarz Team

Download

Please enter your first name.

Please enter a valid email address.

Please enter your name.

Please enter your company name.

Please enter your location.

Marketing permission
Please enter the characters shown in the image
show captcha

The input was not correct.
International Website